Intel NUC11 Cheetah Canyon Disassembly：Dual memory slot + single M.2 interface expansion is easier
Disassemble Intel NUC11 Cheetah Canyon，Let's see how the internal structure is。Unscrew the 8 screws on the bottom + top，You can remove the bottom cover。
The motherboard is equipped with two DDR4 laptop memory slots and an M.2 hard drive interface。The version we received was pre-installed with a memory and a solid state drive，Also, you need to buy separately、Barrier version of hard drive。
The bottom cover is connected to the motherboard with cable，The end is a SATA+ power interface，In addition, there is a fixture，An additional 2.5-inch hard drive can be installed at the bottom to expand storage。
Inner test of the top cover，You can see the wireless charging pad。Three silicone pads are attached to the edge，Used for heat dissipation。
Kingston 16GB 3200MHz DDR4 memory standard，Only one，It is recommended to customize dual memory to form dual channels when purchasing or upgrade it later。
The standard solid state is Samsung 980 Pro，It is one of the fastest top solid states，Supports PCIe 4.0×4 channels。
Remove the solid-state drive and you can see the wireless network card below - Intel AX201 D2W。This wireless network card is designed by Intel for Core processors in the 10th generation and beyond，The master control is integrated into the CPU，Compared with the common AX200，While consistent performance，Have lower power consumption performance。
The interior of the Intel NUC11 Cheetah Canyon uses a metal frame to increase strength，The antenna is installed on the top housing，The two cables of the wireless network card are connected to it，Excellent signal performance。
also，There is an additional motherboard on the metal case，Connected to the large motherboard, the letter board is used for design。There are four silicone，Set on the front panel to implement voice control function。Four holes can also be seen on the front panel，Used to ensure smooth radio。
Remove the motherboard，You can see the processor and cooling configuration on the other side。A whole fan，Almost the same size as the entire motherboard。Adopt a double air outlet design，Except for the tail，There is also a small heat dissipation fin on the side。
Remove the fan，Let's take a look at the more detailed cooling configuration。Dual heat pipe covering processor，A heat pipe is also connected between the fins。Due to the shorter heat pipe，Therefore, the heat can be discharged quickly，Will not accumulate in the machine。
Also on the side，You can see an SD card reader，The motherboard battery is above。
On both sides of the motherboard，All have silver metal shields，Its internal is a Retimer chip with model JHR8040R，Because the 11th generation Core integrates the lightning master control，Therefore, two chips are set up for amplification and compensation signals。
A black heat-smoothing plate is also installed on the outside of the motherboard，After disassembly, you can see a Realtek RTD2173 signal conversion chip，DP1.4 signal can be converted to HDMI 2.1 signal。
